VELOSTER(FS) >2013 > G 1.6 T-GDI > Body Electrical System > Lighting System > Fog Lamps>Repair procedures  
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the lighting switch of the multifunction switch.
(Refer to the "Multifunction Switch")
3.
With the front fog lamp switch, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multifunction switch.

Fog lamp switch

Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the front bumper.
(Refer to the BD group - "Front bumper")
3.
Remove the front fog lamp connector(A) from the front bumper.
4.
Remove the front fog bulb(A) turning it in the counterclockwise direction.

5.
Remove the front fog lamp assembly(A).

Installation
1.
Install the front fog bulb.
2.
Reconnect the lamp connector.
3.
Install the front bumper.